Short Leg Cutting Diagram
Sand all parts. Sand the parts, carefully only make the furniture more comfortable, it will help J rounding hard edges and corners. This will not prevent splinters. 4 Mark the positions of the slats. Carefully mark the positions of the slats on the chair legs. IX this before you start assembling the parts, so that you can mark both legs at the same lime, and get the marks exactly the same on both parts. See Figure 1. 1 Sandwich the matched legs and aprons together, then mark the position of the...
Table Exploded View
1 ft x 5ft x 21 ft V x 3ft Carriage bolts, washers, and nuts 8 V x 4 Lag screws and washers 4 14 x 2ft Flathead wood screws 16 10d Decking nails 1 lb. 14 x 2ft Flathead wood screws 64 10 x 1 Vim Flathead wood screws 32 10d Decking nails 1 Vi lbs. 8d Finishing nails 32
Stretcher Joinery Detail For Bench And Table
block to position the stock for the two outside cuts that mark the edges of the lap. Adjust the height of the saw blade to cut exactly halfway through the width of the 2x4 stock. Make your first cut. turn the board, and make the second. See Figure I. After you have made all the outside cuts in all the stretchers, remove the stop block. Cut away the waste between the outside cuts by making repeated passes over the saw blade. You can aLso use a dado cutter to make these joints. But only if the...
Table Pivot Joint Detail
Nail the slats in place. Nail the slats to the table aprons where you've marked them. Use 4d galvanized finishing nails, or special aluminum or stainless steel nails from a marine supplier. Apply a finish to the table. Finish sand any parts that may still need sanding, then apply a finish to match the chair. Once again, if you've built this project from domestic hardwoods, be sure to seal the grain.
q Rmp
Cut the rabbet joints in the seat supports. Using a dado cuitcr, cut rabbet joints in each end of the seat supports. See Figure I. The rabbets must be cut parallel to the mitered ends. These joints will help to hold the front and back legs steady. 1 Cut rabbet f amp nts in the ends of the seat supports at the same angle as the mitered ends. Use a stop block attached to the fence to gauge the length of the rabbets 4 Assemble the frame. Bolt the seat support to the legs with 3-long carriage...
Middle Frame Joinery 1
W5 assemble the legs to the frames. Clamp them in place temporarily do not screw them in place just yet. Square up the assembly, adjusting clamps as needed. When the legs are square to the frames, remove the right long leg, and insert one long bottom rail and two end rails in their respective holes in both legs. Clamp the leg back in place. Repeat, removing the left short leg. When all the rails are in place except for middle short rails and middle long rails attach the legs to the frames with...
Bench Exploded View
Cut the parts to Me. To make the picnic table with all eight benches, you'll need to purchase ten 2 x 6s, 8' long, twelve 2 x 4s, 8' long, and six 1 diameter dowels, 4' long. Be very picky when you select the wood. You're going to Ik- sitting and eating on those boards. You want them to be fairly clear and free from defects. Rip and cut all the parts to the sizes shown in the Materials List, with the exception of the bench legs. Cut these parts at least 22 long or longer. This extra stock will...